Grip sleeve designing theory

TRUE LOVE grip sleeves

“True Love” silicone grip sleeve is the second product of 7beemers.

Features of ”True Love” silicone grip sleeves

Special ingredients provide good thermal conductivity, suitable for heated grips and non-heated grips.

Acid and alkali resistance, high-temperature resistance, UV resistance, durability, and never dissolve.
Soft tactile, high tension, excellent touch, reducing palm pressure.

The inner layer is completely sealed, perfect water resistant in case of rain or washing.

Excellent controllability, because of the friction as long as hold grips lightly, relax fingers and improve safety.

According to the University of Wisconsin-Madison Occupational Ergonomics and Biomechanics Laboratory University of Wisconsin-Madison and Researchgate GmbH research report, the optimal diameter is 34mm~38mm.

Most grips or heated grips are made of TPR material. Not resistant to acid and alkali, not wear-resistant.
For example: The diameter of BMW’s original grip is 31mm, put on True Love grip sleeves increased by about 4mm, a total of 35mm for better grip.

Grips on other brands of motorcycles with a diameter of 28mm~32mm and a length of 99~115mm can be installed (please refer to the photo).
Three colors: Black, Burgundy, and Bavarian Blue.

Please prevent the bike from toppling when installing.

Lubricate the original grip and handlebar-end with 75% alcohol (Please do not use alcohol that is more than 80%).
Slide the grip sleeve onto the original grip and over the end of the grip.
Hold the handlebar-end part and push inward at least 1/3 of the grips.
Fold a part to increase strength and prevent thrust deformation.
Hold the folded part and push inward to the end.
The grip sleeve is shorter than the grip, you need to push both sleeve’s ends with the palm or thumb gently, until the grip sleeve cover the entire grip. Elongating the shorter silicone so as to make it tighter.
Important: Do not use any tools such as pliers or fingers to pull violently, that will rend the grip sleeve.
After installation, turn on the heating or use hot air to evaporate the alcohol.
The temperature in 40~60 degrees will be enough.